2007 - 2014 TOYOTA FJ CRUISER
Are aftermarket upper control arms required on the 2007 - 2014 FJ Cruiser systems?
No, aftermarket up control arms are not required on 07-14 Toyota FJ Cruiser. The FJ Cruiser UCA’s provide enough alignment adjustment to set the vehicle within the factory alignment spec range. Lifting the vehicle over 2.5” on some vehicles the stock
My 2007-2014 Toyota FJ Cruiser is leaning to the driver side, what can be done to remedy this?
Toyotas have been designed and built with a bias to the driver side due to weight. Toyota FJ Cruisers have both the battery and gas tank on the driver side. New vehicles have this lean right off the showroom floor but is not typically noticed until a
Can ICON 2007-2014 FJ Cruiser rear shocks be used with stock coil springs?
No, the ICON rear FJ Cruiser shocks are designed to gain wheel travel over stock. The added wheel travel provided by the ICON units will allow for the factory coil spring to come loose at full extension. ICON recommends using the ICON coil spring kit
How do you gain access to the grease zerk fitting on the 2007-2014 FJ Cruiser rear lower links?
The ICON 54000 billet lower link system has a greaseable zerk fitting at the axle housing mounting point. The fitting is located at the end of the link, and the grease adapter will have to go from the top down. In order to gain access to that zerk fi
The bolts on my 2011 - 2014 FJ Cruiser skid plate are not long enough?
In some cases the Toyota 4Funner requires two or even three 9/16” washers for the skid plate crossmember. In those cases, the factory bolts are not be long enough to allow proper engagement for the skid plate to the frame. For situations like this, I
Does ICON offer coilovers for 6” lifted FJ Cruiser’s?
Yes, there are several lifted applications available for the 07-14 Toyota FJ Cruiser. The extended and compress lengths of the coilover on your vehicle is required to identify the correct ICON coilover part number for your specific kit. If a coilover
Will the ICON 1-3” lift rear shock work with higher lift heights on this on 2007 - 2014 Toyota FJ Cruiser?
Yes, the ICON rear shock is compatible with higher lift height. The 1-3” recommendation is based on optimum ride quality for the vehicle. Using the ICON shock on higher lift applications may function correctly without damage but right quality may suf
The factory upper control arm bolt and washer cannot be removed, what can be done?
The 07-14 FJ upper control arm bolt washer and flange on the bolt head may come in contact with the fender liner. In some cases, grinding or cutting the fender liner slightly will be required to remove the factory upper control arm bolt. It is also p
Will Toyota Tacoma rear shocks work on an FJ Cruiser or 4runner?
No, the Toyota Tacoma and Toyota FJ/4Runner rear shocks are similar but ICON production rear shocks are not directly compatible between platforms. Please call ICON tech-support for more details (951) 689-ICON.
Will Toyota Tacoma upper control arms work on an FJ Cruiser or 4runner?
No, the Toyota Tacoma and Toyota FJ & 4Runners have different taper pins in the upper control arms. Toyota truck share the same ball joints and Toyota SUV’s share the same ball joint. A truck UCA can be converted to fit an SUV and vice-versa if the b
Are ICON S2 shock system compatible with the FJ Cruiser TRD Big Brake kit?
No, the FJ Cruiser TRD Big Brake kit will come in contact with the secondary shock at full lock. Modifications can be made to the steering to limit his clearance or limit his contact but the system will require custom installation to avoid interferen
What’s the difference between standard and extended travel 2007 - 2014 FJ Cruiser coilovers?
The ICON extended travel coilovers are intended to be paired with aftermarket upper control arms. The added angularity provided by an aftermarket UCA allows ICON engineers to give the vehicle more down travel then the stock coilover. The ICON extende
What is the spring rate on the Long Travel 2007 - 2014 Toyota FJ Cruiser coilover?
The FJ Cruiser long travel coilovers are available with 600lb/in coil springs. ICON Coil Spring Part number: 198500. ICON Coilover Part numbers: 59730 & 59730C. Unlike the non-long travel coilover offerings, there is not a heavier rate coil spring av
What is the nitrogen charge pressure on 2007 - 2014 Toyota FJ Cruiser coilovers?
Toyota Fj Cruiser coilovers are preset from the factory at 250 psi. (ICON Part Number's: 58640, 58645, 58646, 58647). Toyota FJ Cruiser remote reservoir coilovers are preset at 250 psi. (ICON Part Number's: 58740, 58745, 58746, 58747). Remote reservo
Does ICON offer a replacement bearing kits for front 2007 - 2014 Toyota FJ Cruiser coilovers?
Yes, ICON manufactures a bearing service kit for FJ Cruiser coilovers. Part number:. 611067 - TACOMA/FJ/4RNR LOWER CO BRG/SPCR KIT. This kit includes two bearings for clips and all four-space is required for the front lower coilover mount. For more i
How much lift over stock do the ICON 2007 - 2014 Toyota LC200 coilovers provide out of the box?
ICON coilover kits are preset out of the box at the optimum balance between compression and droop travel to give the best ride quality. The ICON coilovers yield approximately 2” of lift overstock from factory setting. Motor size, door configuration,
Is an aftermarket adjustable track bar required on 2007 - 2014 Toyota FJ Cruiser suspension systems?
An aftermarket adjustable track bars is not required but is needed to center the axle underneath the vehicle correctly. ICON always recommend using an aftermarket track bar on solid axle applications to adjust for shift in the axle position due to li
Can ICON 2004 - 2014 FJ Cruiser uniball UCA’s be upgraded to Delta Joints?
All ICON upper control arms, billet aluminum and tubular steel, can be retrofitted to Delta Joints. Delta Joint upgrade kits are sold based on vehicle model. The ICON UCA kit for 04-14 FJ Cruiser is available in billet aluminum and tubular steel. Dep
Are differential drop spacers required on 07-14 FJ suspension systems?
No, front differential drop spacers are not required for ICON suspension systems.
Are differential drop spacers required on 03-19 4Runner suspension systems?
No, front differential drop spacers are not required for ICON suspension systems.
My 07-14 Toyota FJ Cruiser coilovers came with two different size spacers for the lower mount what is the correct orientation?
For 07-14 Toyota FJ Cruiser the large spacer should be oriented forward to clear the sway bar mount to the coilover. The lower shock mount will be offset rearward. The spacer will have to be in the lower mount before installing it between the shock t
My 2010-UP Toyota 4Runner coilovers came with two different size spacers for the lower mount, what is the correct orientation?
For 2010-UP Toyota 4Runner the large spacer should be oriented forward to clear the sway bar mount to the coilover. The lower mount of the shock will be offset rearward. The spacers will have to be inserted in the lower mount before installing it bet
Can ICON 2007 - 2014 FJ upper control arms work with long travel suspension systems?
No, ICON upper control arms are designed to work with a stock width vehicle. Aftermarket long travel systems will require upper and lower control arms that are longer then stock to increase the track width and wheel travel of the vehicle.
What are the spring rate options for the ICON 2007 - 2014 FJ Cruiser coilover?
The FJ Cruiser coilovers are built with an ICON standard production 650lb/in coil spring. 158504 - COIL SPRING 1300.0300.650 BLACK. ICON offers a heavier rate coil spring option that is a 700lb/in spring rate. 158508 - COIL SPRING 1400.0300.0700 BLAC
How much more lift do the expedition coils provide compared to the standard coils on FJ Cruiser?
The expedition coils are designed to yield 3” of lift over stock. The standard coil will provide 2” of lift overstock, with no additional weight added. A vehicle loaded with approximately 440 pounds will sit at the same height as our standard 2” coil
How do ICON extended travel coilovers provide more travel over stock on Toyota FJ Cruisers?
Most independent front suspension systems use the coilover as the component that dictates down travel. The upper control arm is typically the limiting factor due to it's lack of angularity. ICON engineers have found that more travel is available if t
Can I convert my 07-14 FJ Cruiser IFP coil overs to remote reservoir or CDCV?
Yes, non-reservoir coilovers can be upgraded to either Remote Reservoir or CDCV. 51035 - 05-UP TACOMA/07-UP FJ RESI UPGRADE KIT W SEALS PAIR. 51035C - 05-UP TACOMA/07-UP FJ RESI CDCV UPGRADE KIT W SEALS PAIR. Reservoir upgraded kit include all the ne
Can ICON 07-14 FJ Cruiser extended travel coil overs work with long travel suspension systems?
No, extended travel coilovers do not carry over to long travel systems. A new coilover kit is required when switching to long travel. There are 2 options available:. 59730 - 05-UP TACOMA/07-UP FJ 2.5 VS RR COILOVER KIT W LONG TRAVEL. 59730C - 05-UP T
My 07-14 FJ Cruiser coil overs are currently set to the maximum thread showing, what can I do to get more lift?
If you are currently at the max thread recommendation there is an option available to provide more lift. The max compressed length for front suspension is determined by the factory bump stops. The max thread showing is set with this dimension in mind