2008-2019 TOYOTA LAND CRUISER (200 SERIES)
Are aftermarket upper control arms required on the 2008 - 2019 LC200 systems?
No, aftermarket up control arms are not required on 08-19 Toyota LC200. The LC200 UCA’s provide enough alignment adjustment to set the vehicle within the factory alignment spec range. Lifting the vehicle over 2.5” on some vehicles the stock upper con
My 2008-2018 Toyota 200 Series Land Cruiser is leaning to the driver side, what can be done to remedy this?
Toyotas have been designed and built with a bias to the driver side due to weight. Toyota LC200’s have both the battery and gas tank on the driver side. New vehicles have this lean right off the showroom floor but is not typically noticed until a sus
How do you gain access to the grease zerk fitting on the 2008-UP LC200 rear lower links?
The ICON 54000 billet lower link system has a greaseable zerk fitting at the axle housing mounting point. The fitting is located at the end of the link, and the grease adapter will have to go from the top down. In order to gain access to that zerk fi
Does ICON offer coilovers for 6” lifted LC200’s?
Yes, there are several lifted applications available for the 08-19 Toyota LC200. The extended and compress lengths of the coilover on your vehicle is required to identify the correct ICON coilover part number for your specific kit. If a coilover is n
Can 2008 - 2019 Toyota LC200 coil overs be upgraded to a heavier rate coil spring?
No, Icon does not offer a heavier rate coil spring for the 2008 - 2019 LC200. There are other spring manufacturers that make a coil spring of similar dimensions to the ICON coil spring, however the max thread showing would have to be calculated based
How much lift over stock do the ICON 2008 - 2019 Toyota LC200 coilovers provide out of the box?
ICON coilover kits are preset out of the box at the optimum balance between compression and droop travel to give the best ride quality. The ICON coilovers yield approximately 2” of lift overstock from factory setting. Motor size, door configuration,
Can ICON 2008 - 2019 Toyota Land Cruiser (200 Series) uniball UCA’s be upgraded to Delta Joints?
All ICON upper control arms, billet aluminum and tubular steel, can be retrofitted to Delta Joints. Delta Joint upgrade kits are sold based on vehicle model. The ICON UCA kit for 08-19 LC200’s is available in billet aluminum only and will require the
Are differential drop spacers required on 08-19 Land Cruiser suspension systems?
No, front differential drop spacers are not required for ICON suspension systems.
Can Toyota 200 Seires Land Cruiser upper control arms work on Toyota Tundra’s?
No, the Toyota Land Cruiser and Toyota Tundra may seem similar but the lengths of the control arms are in fact different. The Land Cruiser 200 series and Toyota Tundra have their own length control arms as well as different ball joint tapers so they
My 08+ LC200 coil overs are currently set to the maximum thread showing, what can I do to get more lift?
If you are currently at the max thread recommendation there is an option available to provide more lift. The max compressed length for front suspension is determined by the factory bump stops. The max thread showing is set with this dimension in mind